 Topic: Help with sleeve/mandrel size
|
 
|
| Author |
|
admin
Admin Group
Joined: March.10.05
Location: USA
Online Status: Offline
Posts: 304
|
| Posted: February.18.05 at 1:30pm | IP Logged
|
|
|
I've got a Conn 5J tuba in and one of the pistons is out-of-round and
slightly bent. The piston measures 1.0442" and the casing measures
1.046". The Ferree's catalog says Conn tubas should be 1.048. Is the
Conn 5J just an odd size or did Ferree's mismeasure?
Thanks,
Michelle
|
| Back to Top |
|
| |
stevemarti
Technician
Joined: January.19.05
Location: USA
Online Status: Offline
Posts: 7
|
| Posted: February.18.05 at 7:01pm | IP Logged
|
|
|
If it hasn't been replated and refitted, they should all be about same. How does it compare to the others.
Last
time I ordered a sleeve from Ferree's, I specified the piston size
instead of make/model. Alternatively, make one on a lathe to fit a good
piston on the horn.
|
| Back to Top |
|
| |
admin
Admin Group
Joined: March.10.05
Location: USA
Online Status: Offline
Posts: 304
|
| Posted: February.19.05 at 3:12pm | IP Logged
|
|
|
Hi Steve,
Yes, all valves and all pistons measure the same size.
Thanks,
Michelle
|
| Back to Top |
|
| |
|
|
If you wish to post a reply to this topic you must first login
If you are not already registered you must first register
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum
|
Powered by Web Wiz Forums version 7.9Copyright ©2001-2004 Web Wiz Guide
This page was generated in 0.0625 seconds.
|
(0.0)
Active Topics
Memberlist
Search
Help
