| Author |
|
sharonmarrell
Technician
Joined: March.14.05
Location: USA
Online Status: Offline
Posts: 3
|
| Posted: October.31.06 at 10:42pm | IP Logged
|
|
|
Is there anyone that sells a head cork that fits alto flutes or is it that you must sand down a bass head cork all the time. And if you are stuck sanding a bass cork, does anyone have suggestions for getting it even so the hole does not get off center when turning it on a lathe.
|
| Back to Top |
|
| |
admin
Admin Group
Joined: March.10.05
Location: USA
Online Status: Offline
Posts: 304
|
| Posted: November.01.06 at 7:40am | IP Logged
|
|
|
I don't know of any alto head corks. I just sanded down the bass.
I'll put the cork on the rod assembly, chuck the rod (lightly) in the bench motor and sand away with mesh. This will keep the cork diameter concentric with the hole.
Hope this helps.
Michelle
P.S. Good to see you here!
|
| Back to Top |
|
| |
sharonmarrell
Technician
Joined: March.14.05
Location: USA
Online Status: Offline
Posts: 3
|
| Posted: November.01.06 at 8:19am | IP Logged
|
|
|
Good thought. I'm guessing I sand to forcefully, wanting to get it done quickly, and so that warps it. Thanks
|
| Back to Top |
|
| |
admin
Admin Group
Joined: March.10.05
Location: USA
Online Status: Offline
Posts: 304
|
| Posted: November.01.06 at 8:25am | IP Logged
|
|
|
Use the mesh instead of regular sand paper. It sands with light pressure. Let me know if you want the supplier for the mesh and I'll dig it up.
Also use a high speed if on a lathe. I use a bench motor at 1725 RPM and it goes rather quickly.
Michelle
|
| Back to Top |
|
| |
bobbaier
Technician
Joined: February.07.05
Location: USA
Online Status: Offline
Posts: 30
|
| Posted: November.03.06 at 7:40pm | IP Logged
|
|
|
Perhaps ordering from an alto flute maker would get a cork that was sized more appropriately. Size may vary by maker, but I think I'll get a few from Jupiter next time I order.
bob
|
| Back to Top |
|
| |
|
|
If you wish to post a reply to this topic you must first login
If you are not already registered you must first register
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum
|
Powered by Web Wiz Forums version 7.9Copyright ©2001-2004 Web Wiz Guide
This page was generated in 0.1250 seconds.
|
(0.0)
Active Topics
Memberlist
Search
Help
Topic: Alto head corks
